PC 565 PST PIPE SEALANT is a single component, creamy, paste-like anaerobic pipe sealant compound. The product cures when confined in the absence of air between close fitting metal surfaces. It cures slowly, but provides an instant seal. This product is anaerobic with no solvents and no shrinkage and provides a vibration-proof seal that is resistant to most chemicals and corrosion. It can be used on most hydraulic, pneumatic, oil, water and gas connections. This industrial-grade sealant develops controlled, low strength seals on threaded fasteners to facilitate disassembly with standard hand tools.
- Lubricates with PTFE
- For metal fittings, performs well on aluminum, steel plated and brass
- Recommended for tapered & straight pipe threads
- Good temperature and solvent resistance
- Sprinkler Heads
- Pipe Plugs
- Aluminum & Steel
- Pipes & Fittings
- Plated Brass
Directions for Use
Recommended for sealing metal tapered pipe threads and fittings (up to 5 cm/2 in) for industrial applications. For best performance, surfaces should be clean and free of grease. Product should be applied to the thread engagement area in sufficient quantity to fill second and third threads while leaving the first thread free of sealant. Product is normally hand-applied from the tube or brushed directly onto threaded parts. This product performs best in thin bond gaps (0.05 mm). Very large thread sizes may create large gaps which will affect cure speed and strength.
Note: For maximum pressure and solvent resistance, allow at least 72 hours at 72°F for product to fully cure before filling and pressurizing the system.
Full Cure Time: 72 hrs @ 72°F
Temperature Range: -60°F to 300°F (-51°C to 150°C)